Fits: Most AK stamped receivers

Note: Will not fit the M-70. (The M-70 has a stamped receiver, but utilizes a different principle of attaching the stock and the gas piston is longer than a standard AK.)

• Strikeforce Rifle Handguards
• Ergonomic Design
• Non-Slip Textured
• Accent Lines Provide Additional Grip
• Ventilated Upper and Lower Handguards
• Four Forward Picatinny Rail Locations
• One 4″ Picatinny Rail
• Two 2″ Picatinny Rails
• One 2″ Picatinny Rails with Swivel Stud
• Blank Inserts for When Rails are Not In Use
• Rails are Removable and Interchangeable
• Count Towards US Compliance Parts
• DuPont^® Extreme Reinforced Polymer
• Limited Lifetime Warranty
• Made in the USA
   

Notes:

Sling Swivel Studs Accepts ATI’s Sling Swivel (Part # A.5.10.2506) or any Standard Sling Swivel 

SEC922R: ATI products are manufactured in the USA and count towards compliance parts. Contact your local gun shops or shooting ranges for this and other compliance issues.

Warning! – Do Not Over Tighten  Screws (Stripped Holes and Broken Screw Heads are NOT Covered Under the Warranty)